StarTech.com PEXMSATA343 Manual de instrucciones descargar pdf (Pagina 9)

Instruction Manual

3. Under the “Storage Controllers” category (“SCSI and RAID Controllers” in XP) should

be a “Marvell 92xx” device. Right-click on the device and select “Properties” to make

sure it is installed and working correctly.

Note: After a successful installation, some users may notice a yellow icon next to

“Marvell Console ATA Device” under the “Other Devices” category within the Device

Manager. Device performance and operation is not aected by this notication. If you

wish to remove this to icon, run the “drv Setup _V 1017.exe” application located in the

“SATA6G_M9128” folder.

Hard Drive Initialization

If the mSATA SSD or SATA HDD is new or otherwise blank, it may need to be initialized

and formatted before use. Follow the steps below in a Windows interface to initialize

the drive.

1. From the main desktop or start menu, right-click on “Computer” (“My Computer” in

XP), then select “Manage.”

2. In the new Computer Management window, select Disk Management from the left

window panel.

3. A dialog window should automatically appear, asking you to initialize the drive.

Depending on the version of Windows, it will give you the option of either creating

an “MBR” or “GPT” disk. GPT (GUID partition) is not compatible with some older

operating systems, while MBR is supported by newer and older operating systems.

4. Once initialized, locate the Disk that says it is “Unallocated” (check the listed hard

drive capacity to conrm it’s the correct hard drive) and then right-click in the

section that says “Unallocated” and select “New Simple Volume” (“New Partition”

in XP).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Sin comentarios

StarTech.com PEXMSATA343 Manual de instrucciones Pagina 9