StarTech.com PEXMSATA3422 Manual de instrucciones descargar pdf (Pagina 5)

Instruction Manual

LED / Header Status

LED0/LED1 - mSATA

Green LEDs

On: Drive is linked Blinking: Accessing the drive

LED2/LED3 – SATA

LED Pin Headers

On: Drive is linked Blinking: Accessing the drive

LED All – LED

Pin Header

On: When any one of the 4 drives is linked

Blinking: When any one of the 4 drives is accessing

LED and PIN Header LED

Installation

mSATA SSD Installation

WARNING!

SSD Drives and storage adapters require careful handling. If you are not careful

with your SSD Drive, lost data may result. Always handle your drive with caution. Be

sure that you are properly grounded by wearing an anti-static strap when handling

computer components or discharge yourself of any static electricity build-up by

touching a large grounded metal surface (such as the computer case) for several

seconds.

1. Gently slide the mSATA connector on your mSATA SSD into the reciprocal connector

/ slot labeled mSATA0 on the controller card, line the “male” connector widths up on

the SSD, with the slot widths on the controller card to ensure your SSD is inserted

properly.

2. Once inserted, gently press the SSD down toward the black mounting bracket clips,

until the drive clicks into place. The SSD has now been installed.

3. Repeat for a second mSATA SSD if desired, using the mSATA1 slot on the controller

card.

Note: To remove a SSD, push the two black clips near the top of the drive toward each

other while simultaneously gently lifting the SSD up at the clips/latch location, once

released from the bracket clips, slide the drive out.

1 2 3 4 5 6 7 8 9 10 ... 20 21

Sin comentarios

StarTech.com PEXMSATA3422 Manual de instrucciones Pagina 5