StarTech.com 35BAYCF2SAT Manual de instrucciones descargar pdf (Pagina 6)

Instruction Manual

Installation

Front Panel Mount Installation

To install the CompactFlash adapter into the front panel of the computer:

1. Power down the computer.

2. Remove both sides of the computer case (tower), allowing easy access to the front

panel 3.5” drive bay you wish to use (see your computer’s user manual for details, if

necessary).

3. Remove a 3.5” drive bay panel from the front of the computer case (consult your

computer’s user manual for details, if necessary).

4. Fasten the CompactFlash Adapter to the base of the front panel bracket, ensuring

the card slot provided by the adapter is accessible through the opening in the front

of the bracket, using the screws provided.

5. Insert the bracket into the empty drive bay created in step 3, aligning the screw

holes provided by the computer case with the screw holes on the side of the

bracket. Fasten the bracket to the computer case using standard screws (typically,

these screws are provided with the computer case, however StarTech.com oers

a variety of screws and fasteners that would be suitable for this task. Please see

Accessories available from StarTech.com for a listing of available screws.

6. Connect an available SP4 power connector (provided by computer power supply),

to the power port on the CompactFlash adapter.

7. Connect the SATA (for 35BAYCF2SAT) or IDE (for 35BAYCF2IDE) port on the

CompactFlash adapter to an available SATA or IDE connector on the motherboard,

using a standard SATA or IDE cable. Please note that there are two options for IDE

connection, using either a 40-pin or 44-pin connector, based on your motherboard

requirements.

8. Replace the computer case sides. Once the case has been secured, power on the

computer. The CompactFlash adapter is now ready to use.

1 2 3 4 5 6 7 8 9 10 11

Sin comentarios

StarTech.com 35BAYCF2SAT Manual de instrucciones Pagina 6