StarTech.com 2.5" SATA, WiFi Manual de instrucciones descargar pdf (Pagina 8)

Instruction Manual

Client Mode Setup

In this mode, the WiFi Enclosure will act as a

wireless adapter for a host computer system

through a standard Ethernet port. This

will allow the host computer to wirelessly

connect to an existing wireless AP, while

being able to access the resources of the

WiFi Enclosure. Other clients connected to

the wireless AP will also be able to access

the resources on the WiFi Enclosure.

1. Make sure the Mode Switch on the rear

panel of the enclosure is set to “Client

Scan” mode.

2. Connect an Ethernet cable from the enclosure to the Ethernet port on the host

computer system.

3. Connect the included power adapter to the enclosure.

4. Extend the ip up antenna, located along the top edge of the enclosure.

5. Press the power button located along the top edge of the enclosure, near the

rear panel. The LEDs on the front of the enclosure will light up and begin ashing

orange during initialization. Once the Power LED lights up solid green, the unit will

be ready.

NOTE: The default IP address of the enclosure is 192.168.2.1, with automatic IP (DHCP) enabled.

USB Mode Setup

This mode is used for direct USB access to the hard drive, like any standard external

hard drive enclosure. The WiFi capabilities will be disabled while in this mode.

1. Connect the USB cable from the rear panel of the enclosure to an available USB port

on the host computer system.

2. Connect the power adapter from the enclosure to an AC electrical outlet.

3. Press the power button located along the top edge of the enclosure, near the rear

panel. Once the Power LED lights up solid green, the unit will be ready.

4. The enclosure will be automatically detected by the operating system.

Modem/Router

Computer

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 20 21

Sin comentarios

StarTech.com 2.5" SATA, WiFi Manual de instrucciones Pagina 8